Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Unable to open any block... Help please

Created by: RhinoCZ at: 7/23/2009 9:11 PM (4 Replies)

Rating (0)

Thanks 1

5 Entries

7/23/2009 9:11 PM	Rate (0)
RhinoCZ Posts: 11 Rating: (0)	Hi there, till today I was using STEP 7 for with no problem. Now, when I try to open any block (OB, FB, FC) in any project LAD/STL/FDB writes message "S7KAFAPX - Unable to create empty document" and does not open source. I had tried to reinstall Step7 with no result, XMLPasteCopy have no effect too. Does anybody know what to do? STEP7 version 5,4 + SP4 Windows Vista Ultimate SP1 Thanks a lot.
RhinoCZ Posts: 11 Rating: (0)	Last edited by: RhinoCZ at: 7/23/2009 9:12 PM Last edited by: RhinoCZ at: 7/23/2009 9:11 PM
Suggestion To thank Quote Answer

7/24/2009 6:16 AM	Rate (0)
umencho Grandmaster Joined: 3/21/2006 Last visit: 12/31/2025 Posts: 10239 Rating: (1183)	Hi, Try with update Step7 to SP5. Look at http://support.automation.siemens.com/WW/view/en/36184684 Hope this will helps. Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

7/24/2009 8:36 AM	Rate (0)
TomDeWou Platinum Member Joined: 11/15/2006 Last visit: 3/26/2025 Posts: 1319 Rating: (176)	Do you have an notebook with graphics tablet functionality? If so, did you activate it? Because as far as I know a colleague of mine had some problems opening blocks on a graphics tablet notepad. After removing the drivers for this it worked ..
	Have Fun! TomDeWou
Suggestion To thank Quote Answer

7/24/2009 8:46 AM	Rate (0)
IBN-Service Posts: 8946 Rating: (1000)	RhinoCZ Hi there, till today I was using STEP 7 for with no problem. Now, when I try to open any block (OB, FB, FC) in any project LAD/STL/FDB writes message "S7KAFAPX - Unable to create empty document" and does not open source. I had tried to reinstall Step7 with no result, XMLPasteCopy have no effect too. Does anybody know what to do? STEP7 version 5,4 + SP4 Windows Vista Ultimate SP1 Thanks a lot. May be you can get some inspiration here: http://www.plctalk.net/qanda/showthread.php?p=138834
IBN-Service Posts: 8946 Rating: (1000)
Suggestion To thank Quote Answer

7/24/2009 10:47 AM	Rate (0)
RhinoCZ Posts: 11 Rating: (0)	Thanks for your tips, SP5 was not work too. During "brainstorming" I try to switch on User Account Control utility (don't know right english translation) in Win and now it works! Butterfly effect? :) Thanks to all again.
RhinoCZ Posts: 11 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users TomDeWou

|

Share this page:

Share this page on...

Follow us on