Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

SET Coils not setting

Created by: henno2000 at: 8/18/2009 10:35 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

8/18/2009 10:35 AM	Rate (0)
henno2000 Posts: 177 Rating: (0)	Hi, We have wrote a program that is to be used in 6 PLCs. The program is identical in each one. SET coils have been used, but for one of the PLCs, the coil never stays set when you remove the input. This happens for all types address (memory bits, DB addresses and TEMP values) Could someone please give an explanation as to why this is occurring? Regards, henno2000
henno2000 Posts: 177 Rating: (0)
Suggestion To thank Quote Answer

8/19/2009 7:54 AM	Rate (0)
TomDeWou Platinum Member Joined: 11/15/2006 Last visit: 3/26/2025 Posts: 1319 Rating: (176)	Are those 6 plc all have the same verion of firmware, or are they even different plcs?
	Have Fun! TomDeWou
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on