Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Process Image

Created by: multimeter at: 10/30/2009 11:24 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

10/30/2009 11:24 AM	Rate (0)
multimeter Advanced Member Joined: 8/31/2006 Last visit: 11/14/2025 Posts: 20 Rating: (0)	Hi all, I am having problems to get rid of some warnings during my compile using CFC charts. basically I think that the process image setting is out of range within my hardware configuration. I am using a (S7-414-4) 6ES7 414-4HM14-0AB0 CPU. the warning is shown below. Can someone please point me in the direction to configure the process image to cover the input word PIW528 (this is the start address of my analogue input cards, all the others are ok) W: Parameter access WC1 Slot 09 AInOvRule.PIW 528.RawIn to the "WC_1_4A_PT1" address does not occur via the process image, rather via direct I/O access. The rule should be a process image access (see details)." thanks multimeter

Suggestion To thank Quote Answer

10/30/2009 2:46 PM	Rate (0)
Ammy Posts: 1525 Rating: (159)	Hi Multimaster, Please see the attached Screen shot & checked the setting in the CPU properties & change it as per your requirment but not more than the maximum range. This the one setting which due to this i was also face the problem. hope this will help to you. Attachment PIQ.JPG (270 Downloads)
Ammy Posts: 1525 Rating: (159)
Suggestion To thank Quote Answer

10/30/2009 3:23 PM	Rate (0)
multimeter Advanced Member Joined: 8/31/2006 Last visit: 11/14/2025 Posts: 20 Rating: (0)	Ammy - you are a star! thanks for the help multimeter

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on