Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

WinCC Flex problem

Created by: ZoranM at: 8/6/2006 9:12 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

8/6/2006 9:12 PM	Rate (0)
ZoranM Posts: 7 Rating: (0)	Hi! I have a problem with a fresh installed WinCC Flex 2005. It was installed on a PC with a also fresh installed WinXP SP2. After I run my project in a S7 WinCC flex starts to open and than stops, somewhere in the middle on the scale. I tried to remove and than again to install WinCC Flex but result was the same. Also I tried to instal SP1 for WinCC flex but there was the same. I suppose that something in Windows stopping the software, or something is missing, but what? There is no error massages. Before installation of new Windows everything had been working fine. Thank you!
ZoranM Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

8/7/2006 9:47 AM	Rate (0)
skimmer Bronze Member Joined: 9/5/2007 Last visit: 3/7/2023 Posts: 317 Rating: (18)	It does sound as if something has screweed up along the way. If it's a new build I think you might be better off to start again with a format and reinstall of Windows. You could spend a lot of time trying to fix it with no guarantee of making progress. As it's a new build I would bite the bullet and start again. [:(]

Suggestion To thank Quote Answer

8/9/2006 12:13 AM	Rate (0)
ZoranM Posts: 7 Rating: (0)	I solved it. I reinstalled Microsoft.Net Framework 1.1 platform and now WinCC Flex works fine. Best regards.
ZoranM Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on