Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Step 7 Urgent

Created by: Ing. Hass at: 3/18/2010 12:17 AM (5 Replies)

Rating (0)

Thanks 1

6 Entries

3/18/2010 12:17 AM	Rate (0)
Ing. Hass Posts: 50 Rating: (0)	Hello good evening, I have a problem with step 7, I am using it from a Field PG M2, and make an Ethernet connection to program a plc, then I use the mpi port but I can not use it, because when setting the interface pg / pc and try to configure the port or other port mpi gives me the following error: "one or more interface settings are blocked," and I can not communicate and by any door, and say I can not program the plc, thank you very much for your attention ...
Ing. Hass Posts: 50 Rating: (0)
Suggestion To thank Quote Answer

3/18/2010 1:26 AM	Rate (0)
umencho Grandmaster Joined: 3/21/2006 Last visit: 1/10/2026 Posts: 10247 Rating: (1183)	Hello, Perhaps in current project you already assigned ethernet adapter for communication. I mean you put PC Station there. So, remove in to the project from PC station ethernt connection and then you can change in PG/PC Interface MPI type of adapter... Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

3/18/2010 1:41 AM	Rate (0)
Ing. Hass Posts: 50 Rating: (0)	hello, thanks for your response, I try but I can not connect the pg / pc to any of the settings, as it displays the same block error parameterization, the only option that comes out is that of Iso. Ind. Ethernet communication that if you give me, thanks!
Ing. Hass Posts: 50 Rating: (0)
Suggestion To thank Quote Answer

3/18/2010 1:45 AM	Rate (0)
umencho Grandmaster Joined: 3/21/2006 Last visit: 1/10/2026 Posts: 10247 Rating: (1183)	Is it possible to attach here current hardware configuration?

Suggestion To thank Quote Answer

3/18/2010 3:05 AM	Rate (0)
Ing. Hass Posts: 50 Rating: (0)	If you can make the configuration of hardware, but you can not put the interface to which you are connecting to the pg plc mpi does not work, nor with tcp / ip or others only with ethernet, the other says they are blocked parameterizations in setting the pg/pc interface
Ing. Hass Posts: 50 Rating: (0)
Suggestion To thank Quote Answer

3/18/2010 11:35 PM	Rate (0)
Ing. Hass Posts: 50 Rating: (0)	I solved the problem, should go to the settings in windows network connections in your network connection and clear the check boxes SIMATIC Industrial Ethernet (ISO) and the Internet Protocol (TCP / IP) and then accept and go to Step 7 to configure the MPI port and this is unlocked, thanks for your attention
Ing. Hass Posts: 50 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users umencho

|

Share this page:

Share this page on...

Follow us on