Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Write safety output from the normal program

Created by: elmucho at: 6/2/2010 11:03 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

6/2/2010 11:03 AM	Rate (0)
elmucho Posts: 20 Rating: (0)	Hello, I want to write a safety output from a fc_fdbinstead of afc_F-fdb. If i do this thesafety outputcard detects an fault and the io passivated.. Is it possibleto write a fail safe output from the regular program? Thank you
elmucho Posts: 20 Rating: (0)	Last edited by: elmucho at: 6/2/2010 11:16 AM
Suggestion To thank Quote Answer

6/2/2010 11:13 AM	Rate (0)
yy1 Posts: 535 Rating: (112)	Dear elmucho, no, you always have to write the safety-output from your failsafe-program, because the safety-module needs additional data (signature / ...), which is added by the failsafe-program. Which fault is detechted? Did you program a reintegration of the safety-module? Best regards, yy1
yy1 Posts: 535 Rating: (112)
Suggestion To thank Quote Answer

6/2/2010 11:18 AM	Rate (0)
elmucho Posts: 20 Rating: (0)	Dear yy1, Communication errors and the io module gets passivite Did you program a reintegration of the safety-module? What do you mean ? Thank you.
elmucho Posts: 20 Rating: (0)	Last edited by: elmucho at: 6/2/2010 11:18 AM
Suggestion To thank Quote Answer

6/2/2010 11:26 AM	Rate (0)
elmucho Posts: 20 Rating: (0)	I have programmed a reintegration of the safety-module. I have used automatic reintegration.
elmucho Posts: 20 Rating: (0)
Suggestion To thank Quote Answer

6/2/2010 12:14 PM	Rate (0)
yy1 Posts: 535 Rating: (112)	Dear elmucho, is the DIP-switch of your safety-module correct (same as in HW-Konfig)? Perhaps you can publish the content of the diagnostic-buffer. Best regards, yy1
yy1 Posts: 535 Rating: (112)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on