Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Homing, Simotion D 425

Created by: Subba at: 7/22/2009 10:41 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

7/22/2009 10:41 AM	Rate (0)
Subba Posts: 39 Rating: (2)	Dear all, Please let me know how toconfgure the log.address of homicg output cam parameter of homing section. Please let me know how we can link the onboard ios with this logaddress. Thanks in advance
Subba Posts: 39 Rating: (2)
Suggestion To thank Quote Answer

7/22/2009 11:12 AM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 12/19/2025 Posts: 22816 Rating: (3073)	Hello, the logAdress for the homing output cam cam you can configure in the homing mask of the axis. Choose mode "Homing output cam and encoder zero mark". There are two filds for the log adress. In the first field (Log. adress of homing output) you must specify the Byte adress of the used output. In the second field (Bit number) you must specify which bit in the byte is the cam mark. To link the I/O's of the D425 use following table: Start address message frame CU +3, bit 1 DI/DO9 Start address message frame CU +3, bit 2 DI/DO10 Start address message frame CU +3, bit 3 DI/DO11 Start address message frame CU +3, bit 5 DI/DO13 Start address message frame CU +3, bit 6 DI/DO14 Start address message frame CU +3, bit 7 DI/DO15 Set the P922 of the CU to 390 and reset the parameter to 999 so you get the BICO connections for the table. tranfer this config you get the adresses for the CU. now you can build the log adress: input adress of Cu + Offset of the uses DI. Regards Christoph Attachment homing.jpg (452 Downloads)

Suggestion To thank Quote Answer

7/27/2009 3:18 PM	Rate (0)
Subba Posts: 39 Rating: (2)	Dear ChristophD, Thankyou for your support and was really helpful. I am trying to program something to acknoldge the faults using the MCC command - "Acknowledge technology object alarms", but i am getting compilation errors. Please let me know how to program a fault acknowlede condition using a input (Push button - Reset). Subbarao
Subba Posts: 39 Rating: (2)
Suggestion To thank Quote Answer

7/27/2009 4:54 PM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 12/19/2025 Posts: 22816 Rating: (3073)	Hello, which error occurs in the MCC? Regards Christoph

Suggestion To thank Quote Answer

7/2/2010 1:50 PM	Rate (0)
Kristoffel Posts: 31 Rating: (0)	Is it possible to explain further the link betweenthe homing sensor connected to an input of the D425 and the logical address used in the "homing output cam and encoder zero mark"? I don't understand the explanation that is given...
Kristoffel Posts: 31 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on