Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Motor status

Created by: yogesht at: 7/17/2010 7:04 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

7/17/2010 7:04 AM	Rate (0)
yogesht Posts: 72 Rating: (0)	Hi All, I am using S7 300 2PN/DP cpu, I want to show status of motor, in wincc v7.0. for that i made logic in s7300 as below but its not working, please give me proper solution. AN "trip" L 1 T MW 100 AN "local_remot" L 2 T MW 100 AN "FB_FLT" L 3 T MW 100 AN "EM_STOP" L 4 T MW 100 A "PLC_OP" L 5 T MW 100 AN "PLC_OP" L 6 T MW 100
yogesht Posts: 72 Rating: (0)
Suggestion To thank Quote Answer

7/17/2010 9:29 AM	Rate (0)
IBN-Service Posts: 8946 Rating: (1000)	L an T is independendly from the VKE (Status of AN - command)! You must use a JUMP - command!
IBN-Service Posts: 8946 Rating: (1000)
Suggestion To thank Quote Answer

7/17/2010 10:19 AM	Rate (0)
IBN-Service Posts: 8946 Rating: (1000)	Just an easy example: [code] L #Datum_6 AN #Sel_6 // Data 6 is selected ? JC DAT5 T #Wert BEC DAT5: L #Datum_5 AN #Sel_5 // Data 5 is selected ? JC DAT4 T #Wert BEC DAT4: L #Datum_4 AN #Sel_4 // Data 4 is selected ? JC DAT3 T #Wert BEC // Transfer Data 4 to targetword DAT3: L #Datum_3 AN #Sel_3 // Data 3 is selected ? JC DAT2 T #Wert BEC // Transfer Data 3 to targetword DAT2: L #Datum_2 AN #Sel_2 // Data 2 is selected ? JC DAT1 T #Wert BEC // Transfer Data 2 to targetword DAT1: L #Datum_1 AN #Sel_1 // Data 1 is selected ? JC DAT0 T #Wert BEC // Transfer data 1 to targetword DAT0: L #Datum_0 T #Wert // No spezific selection ? // // Transfer Data 0 to targetword [/code]
IBN-Service Posts: 8946 Rating: (1000)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on