Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

More Analog Module problems

Created by: Andy Moods at: 9/28/2010 5:40 PM (2 Replies)

Rating (0)

Thanks 2

3 Entries

9/28/2010 5:40 PM	Rate (0)
Andy Moods Posts: 33 Rating: (0)	Hi Can someone please help me. I have setup the hardware config to match the physical layout and once i load the program into the PLC, the analog module is blinking red and the CPU is flashing error. I have tried intially to disconnect all the wires and it stays the same. as it stands, i have only connected: pin 1 : +24vdc pin 2: 0V pin 3 ; 0V It is still flashing there is nothing else connected. Pleas help Andy
Andy Moods Posts: 33 Rating: (0)
Suggestion To thank Quote Answer

9/29/2010 11:57 AM	Rate (0)
Denilson Pegaia Diamond Expert Joined: 9/23/2005 Last visit: 12/31/2025 Posts: 4435 Rating: (1487)	Hi, What is the order number of your analogic module?
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

9/29/2010 2:25 PM	Rate (0)
Andy Moods Posts: 33 Rating: (0)	Hi Thanks. I have just sorted it out. the problem was power was on the wrong level. top instead of bottom. Thanks again
Andy Moods Posts: 33 Rating: (0)
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users umencho Denilson Pegaia

|

Share this page:

Share this page on...

Follow us on