Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Logic development in S7 V5.4 SP4 but want to open in S7 V5.4 SP3

Created by: anup20 at: 11/9/2010 6:26 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

11/9/2010 6:26 AM	Rate (0)
anup20 Posts: 13 Rating: (0)	Hello All, I have a PLC backup which is developed in S7 V5.4 SP3 but I installed S7 V5.4 SP4. So if I will modify the logic of PLC backup in S7 V5.4 SP4 and after that I will open in S7 V5.4 SP3 and modify again then Is there any possiblilty to get the error during development or backup corruption?
anup20 Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

11/9/2010 7:24 AM	Rate (0)
umencho Grandmaster Joined: 3/21/2006 Last visit: 10/16/2025 Posts: 10239 Rating: (1183)	Hello, I'll "jump" your question and ask directly - why didn't you upgrade to SP5 both PCs? Basically you can open with older version without any error. Of course hardware modules which are used and version of blocks... Simply update to SP5 and that's it. (http://support.automation.siemens.com/WW/view/en/36184684) BR, Hristo Mihalev
	Last edited by: UMENCHO at: 11/9/2010 7:24 AM
Suggestion To thank Quote Answer

11/9/2010 9:05 AM	Rate (0)
anup20 Posts: 13 Rating: (0)	Thanks. I got this PLC backup in S7 V5.4 SP3 from client directly and now i have to modify it with S7 V5.4 SP4.After that changes, it will be opened in S7 V5.4 SP3by client only.
anup20 Posts: 13 Rating: (0)
Suggestion To thank Quote Answer

11/9/2010 9:35 AM	Rate (0)
umencho Grandmaster Joined: 3/21/2006 Last visit: 10/16/2025 Posts: 10239 Rating: (1183)	Aaa Ok, So you have backup of the project. Make the necessaries changes there and send it to the customer. At least you can try it. I think there will not have any problems. BR, Hristo Mihalev

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on