Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

611u ok at Point to point, error when in network

Created by: rlyean at: 1/6/2011 11:47 PM (1 Replies)

Rating (0)

Thanks 2

2 Entries

1/6/2011 11:47 PM	Rate (0)
rlyean Posts: 31 Rating: (2)	here is the situation: I have existing 611u and cpu 315-2dp...only this 2 are connected to the profibus network (point to point).. When I upgrade the machine i change the cpu with a higher version of cpu315-2dp..then i add 2-micromaster and 1-HMI TP277.. When i powered up i have a error message of A 831 for Servo 611u, when i check the cause in the manual all the configuration is good..about the address assign, the running condition of master etc except for this one: *"An illegal parameterization or configuration was received.*" I dont know what im missing may be this one will help..when i removed the other slaves of the profibus and only the cpu and 611u the drive is ok "run mode"..when i connect again the other slaves the error A831 appears again. also in the same case when i am trying to search online device by SimoComU, i can reach the 611u when alone in the network and failed when together with the other slave.. thank you for you time..
rlyean Posts: 31 Rating: (2)
Suggestion To thank Quote Answer

1/19/2011 6:31 AM	Rate (0)
rlyean Posts: 31 Rating: (2)	i just update the firmware..and now the drives working fine.
rlyean Posts: 31 Rating: (2)
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users O_Moderator Ekalavya

|

Share this page:

Share this page on...

Follow us on