Navigation

kp700 screen call from plc

Created by: GAS2 at: 11/10/2011 1:39 PM (1 Replies)

11/10/2011 1:39 PM	Rate (0)
GAS2 Posts: 66 Rating: (0)	Dear All, I am using WinCC comfort v11 for KP700 HMI. On perticullar event I have to call perticullar screen from PLC (S7 313C). I gone through help but I found only read screen number option. Howshall I configure this? thank you.
GAS2 Posts: 66 Rating: (0)
Suggestion To thank Quote Answer

11/10/2011 2:12 PM	Rate (1)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 12/24/2025 Posts: 9097 Rating: (1202)	Hello GAS2, Have you seen this thread: /tf/WW/en/Posts/61811 Best regards, Wizard

Suggestion To thank Quote Answer