Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Open Communication Wizard in TIA Portal v11 SP1

Created by: Richard Goodchild at: 12/12/2011 4:31 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

12/12/2011 4:31 PM	Rate (0)
Richard Goodchild Posts: 6 Rating: (0)	Hello, We have migrated an existing Step 7 project into TIA Portal v11 SP1. The original project used an ET200S 151-8 CPU with CPU connections set up using the Open Communication Wizard tool Siemens provide free to configure CPU connections in the ET200S processor. Having migrated the project into Portal, I cannot now find any way of easily configuring the connections in the project (the only way to change them is to alter the datablocks containing the connection information manually). Is there a new version of OCW for TIA Portal v11 or do any connections for the ET200S CPUs now have to be manually added by creating the datablocks? Or are the connections configured in some other way? I cannot see any evidence of them in the "connections" section of "Devices and networks" either. Richard Goodchild.
Richard Goodchild Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

12/13/2011 8:59 AM	Rate (0)
taxflor Silver Member Joined: 1/26/2011 Last visit: 11/12/2024 Posts: 243 Rating: (67)	Hi Richard, to your first question, no there isn't a version for TIA Portal available. The Wizard is only for STEP 7 V5.X available. Tothe other thing, it's a good question where i also would have a solution. I've never tried this in TIA but itry toreconstruct this and maybe i can give you an answer :) nice greetings bigfoot

Suggestion To thank Quote Answer

12/13/2011 10:00 AM	Rate (0)
Richard Goodchild Posts: 6 Rating: (0)	Thanks, Bigfoot. If I get some time I might investigate further too and post the results. Richard.
Richard Goodchild Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on