Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

EM_PC Install with Mec31

Created by: realface at: 7/28/2011 9:39 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

7/28/2011 9:39 AM	Rate (0)
realface Posts: 10 Rating: (0)	Hi~ All I have some problem on EM_PC install. Now my systems is EM_PC+EM_PCI-104+MEC31 Software is Winac2010+Simatic Net 2008, If i just use EM_PCI-104+MEC31,system can be boot in normal status. from my pc to remote MEC31 to operate is okay. but i try to install EM_PC+EM_PCI-104+MEC31,even just EM_PC+MEC31. When i trun on power, all lamp on front of MEC31 is lit and no more work. Havei lost any step before i install EM_PC? If anyone have experience about this module,please share yours. thank you. PHIL
realface Posts: 10 Rating: (0)
Suggestion To thank Quote Answer

12/13/2011 9:42 AM	Rate (0)
taxflor Silver Member Joined: 1/26/2011 Last visit: 11/12/2024 Posts: 243 Rating: (67)	Hi realface, what's the current Firmware version of your MEC 31? best regards bigfoot

Suggestion To thank Quote Answer

1/3/2012 5:28 PM	Rate (0)
gre_m Posts: 947 Rating: (45)	Hi! what module install in EM-PCI? You connect monitor to EM-PC and try safety boot? You see Device manager Windows? I thing - you should enter in Setup BIOS and check IRQ. Possible you have conflict IRQ
gre_m Posts: 947 Rating: (45)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on