Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

PEEK/POKE I/O addresses

Created by: aerrree at: 4/23/2012 9:40 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

4/23/2012 9:40 AM	Rate (0)
aerrree Posts: 31 Rating: (1)	Hi, I am trying to use PEEK in order to read individual bits of an input word (the status word of a MM420). According to the manual i should use PEEK_BOOL and use area 16#81. My question is: how do i specify the input address? Do i use the ByteOffset to start at the input address? I do not have the option to test or simulate the code. Thanks in advance
aerrree Posts: 31 Rating: (1)	Last edited by: aerrree at: 4/23/2012 10:07 AM
Suggestion To thank Quote Answer

4/23/2012 1:27 PM	Rate (0)
billwest Posts: 510 Rating: (120)	You are correct. Set the DB Nr = o nad use the byte offset to specify the starting address of the byte you want to read. Good luck, billwest
billwest Posts: 510 Rating: (120)
Suggestion To thank Quote Answer

4/23/2012 2:31 PM	Rate (0)
aerrree Posts: 31 Rating: (1)	Thanks, i will try that.
aerrree Posts: 31 Rating: (1)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on