Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Transfer application to TP177A through PLC with WinCC flex 2005 sp2

Created by: Kolma at: 9/30/2005 1:46 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

9/30/2005 1:46 PM	Rate (0)
Kolma Posts: 57 Rating: (1)	Hello! I can't transfer application through PLC from PC to MPI and over PB port to TP177A. I use WinCC flexible 2005 sp2 compact. I also noticed that in control panel where you choose adapter there is only MPI. Any ideas, Kolma
Kolma Posts: 57 Rating: (1)
Suggestion To thank Quote Answer

10/5/2005 10:21 PM	Rate (0)
mbn Regular Member Joined: 9/29/2005 Last visit: 4/11/2025 Posts: 25 Rating: (0)	Hello Have you checked that in the control panel, under tansfer, there is checked out at enable channel and remote? Brg. Morten

Suggestion To thank Quote Answer

10/6/2005 11:35 AM	Rate (0)
Kolma Posts: 57 Rating: (1)	Thanks for tip, but I did all that you suggested but I doesn't work. I don't know what is wrong. Kolma
Kolma Posts: 57 Rating: (1)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on