Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

S7-1200 and KTP300 HMI

Created by: banconi at: 5/8/2012 9:18 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

5/8/2012 9:18 PM	Rate (0)
banconi Silver Member Joined: 3/19/2010 Last visit: 6/15/2025 Posts: 439 Rating: (12)	Hi, I am first time using Step 7 Basic (TIA), and I have stumbled on a first step. I have CPU 1212C and HMI KTP300. I have added CPU in hardware configurator, but I cannot do the same with my HMI. This model is not listed in Catalog!! Only KTP400 and above are listed in catalog. What sould I do?

Suggestion To thank Quote Answer

5/9/2012 8:16 AM	Rate (0)
koenb Posts: 122 Rating: (23)	What version of TIA / WinCC do you use ? KP300 was added in V11 version. latest version is V11 SP2 with update 2.
koenb Posts: 122 Rating: (23)
Suggestion To thank Quote Answer

5/9/2012 8:36 AM	Rate (0)
banconi Silver Member Joined: 3/19/2010 Last visit: 6/15/2025 Posts: 439 Rating: (12)	I have TIA version 10.5, is it possible to do it with this version with some kind of hardware catalog update? Best regards, Bane

Suggestion To thank Quote Answer

5/9/2012 8:52 AM	Rate (0)
koenb Posts: 122 Rating: (23)	banconi I have TIA version 10.5, is it possible to do it with this version with some kind of hardware catalog update? Best regards, Bane Hi Bane , As far as I know there is no Hardware Support Pack or SP that will add the KP300 to V10.5. for 10.5 there is a SP2 with HSP 1,2 and 3 but your HMI is not listed.
koenb Posts: 122 Rating: (23)
Suggestion To thank Quote Answer

5/9/2012 10:44 AM	Rate (0)
Mc Muffin Posts: 495 Rating: (58)	KP300 is only supported in Tia PortalWinCC V11! I hope that helps
Mc Muffin Posts: 495 Rating: (58)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

TIA WinCC Installation Options General

Follow us on