Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Can not Connect with a WINLC RTX V4.6

Created by: GanzGenau at: 11/6/2012 5:37 PM (4 Replies)

Rating (3)

Thanks 0

5 Entries

11/6/2012 5:37 PM	Rate (0)
GanzGenau Posts: 36 Rating: (0)	Dear friends I have a WinLC RTX V4.6 installed in a computer. Im trying to connect with a S7 station to download a test program. I dont have a siemens card in the RTX computer, i want to connect using the network adapter. I configued a IE adapter using the siemens.net. After i configured the PC/PG interface and everything seems OK, but when i try to finde the RTX in my net i dont find it. If I do a PING to the RTX computer works fine. I cant find where is the mistake. Could you help me?? Thanks in advance Regards
GanzGenau Posts: 36 Rating: (0)
Suggestion To thank Quote Answer

11/6/2012 6:14 PM	Rate (0)
smoky Experienced Member Joined: 8/15/2011 Last visit: 1/12/2026 Posts: 145 Rating: (13)	hello, maybe same problem like here /tf/WW/en/Posts/82419#top - PING OK. - remote desktop OK.? - router?

Suggestion To thank Quote Answer

11/7/2012 8:45 AM	Rate (0)
GanzGenau Posts: 36 Rating: (0)	Hello Im going to check the steps of the other post, but i can do a PING to the RTX equipment. I dont know if i need a special version of STEP7 to work with RTX 4.6. In my network i have other PLCs (416, pannel PC) and when i check the network with the STEP7 appears without problem... I will try with TIAPORTAL too
GanzGenau Posts: 36 Rating: (0)
Suggestion To thank Quote Answer

11/7/2012 10:37 AM	Rate (2)
smoky Experienced Member Joined: 8/15/2011 Last visit: 1/12/2026 Posts: 145 Rating: (13)	hello GanzGenau ...I dont know if i need a special version of STEP7 to work with RTX 4.6. ...
	Last edited by: smoky at: 11/7/2012 10:43 AM also check PG/PC interface on RTX computer (start->settings->control panel->set PG/PC interface...for TCP... Last edited by: smoky at: 11/7/2012 10:38 AM If you also have WinAC RTX 4.6 in your STEP 7 project, then your STEP 7 version is OK.
Suggestion To thank Quote Answer

11/8/2012 1:28 PM	Rate (1)
taxflor Silver Member Joined: 1/26/2011 Last visit: 11/12/2024 Posts: 243 Rating: (67)	Hello, please check the settings from the station configurator and the hardware configuration in your STEP 7 Proejct. Maybe there are any differences and this is why you can't find the WinAC RTX in your connections. Also please check the settings from the PC/PG interface (like smoky already said). Maybe it helps when you set the interface to internal and the to the correct one. If you have some other/more information please let us know. And if you have some screenshots from error messages or anything else --> upload them here. nice greetings, bigfoot

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on