Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Siemens Servo Motor with non siemens Servo Drive.

Created by: RajD at: 12/17/2012 11:43 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

12/17/2012 11:43 AM	Rate (0)
RajD Advanced Member Joined: 8/2/2010 Last visit: 6/25/2025 Posts: 45 Rating: (1)	Hi, Can I run Siemens Servo Motor with non siemens Servo Drive? Thanks & Regards

Suggestion To thank Quote Answer

12/18/2012 12:03 AM	Rate (0)
Deleted User Posts: 767 Rating: (69)	Hello AryaP, The question as to whether a Siemens servo motor can be used with a non Siemens servo drive depend upon specifically which Siemens Servo Motor. In general, as long as the feedback type of encoder is supported by the non Siemens servo drive then this should be possible; however, the programmer will likely need to enter servo drive parameters in the non Siemens servo drive plus the drive may not quite use the same terms such as # poles vs. # pole pairs, etc. You would also need to get the full information from Siemens Planning Guide with such data as torque constant, standstill torque, rated torque, rated speed, etc. Caution if the Siemens servo motor has DRIVE-CLiQ encoder then will likely not be able to use with a non Siemens servo drive. Deputy
Deleted User Posts: 767 Rating: (69)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on