Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

PLCSIM and WINCC V11

Created by: Vicky5729 at: 2/12/2013 8:30 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

2/12/2013 8:30 AM	Rate (0)
Vicky5729 Posts: 35 Rating: (0)	Hi all, I was able to create a Connection between the PLCSIM and WINCC V11. And the Communication is working fine. I am trying to communicate using PLCSIM ISO. But every time when i make some changes in the TIA Portal and compile, the Connection is lost between the TIA and the PLCSIM. By Default the Connection in the TIA is set to PLCSIM (TCP/IP). Since I am Communicating through ISO, it is getting reset I think. Is there any Solution for this..??? Thanks In Advance..
Vicky5729 Posts: 35 Rating: (0)	Last edited by: O_Moderator at: 2/12/2013 9:25 AM new subject after splitting from /tf/WW/en/Posts/85938#top
Suggestion To thank Quote Answer

2/12/2013 3:29 PM	Rate (0)
Tweety Posts: 3037 Rating: (192)	Hello, Which version of WinCC V11 do you use? Why do you use PLCSIM (ISO)? Do you use PLCSIM with the Runtime simulator? Tweety
Tweety Posts: 3037 Rating: (192)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

TIA WinCC Communication

Follow us on