Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Logo plc first time start, hourglass icon

Created by: Osman_ at: 2/19/2013 12:00 PM (2 Replies)

Rating (0)

Thanks 2

3 Entries

2/19/2013 12:00 PM	Rate (0)
Osman_ Posts: 243 Rating: (4)	Hello, It's my first time to use logo plc. I bought logo plc from siemens. When I power-on logo plc, I see hourglass icon in screen and I can't remove it. I tried to connect logo plc to pc, but LOGO!Soft Comfort V7.0 can't connect to logo plc. I did not buy logo memory card. do I have to use a memory card with logo plc? I made some search in internet, I found an article. it says " if you see hourglass in screen, power off logo plc, power on again, click "<" and ">" buttons until you see the english menu. I tried it, but nothing changed. I'm pushing ESC button, I can't remove hourglass icon. Now there is no program in logo. can you help please? thank you Attachment logoo.jpg (215 Downloads)
Osman_ Posts: 243 Rating: (4)
Suggestion To thank Quote Answer

2/19/2013 1:25 PM	Rate (0)
umencho Grandmaster Joined: 3/21/2006 Last visit: 1/10/2026 Posts: 10247 Rating: (1183)	Osman_ ...power off logo plc, power on again, click "<" and ">" buttons until you see the english menu. press,andOKtogether until the English menu entries appear. If that didn't help -Support Request Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

2/19/2013 3:09 PM	Rate (0)
Osman_ Posts: 243 Rating: (4)	thank you for answer. I resolved the problem. it was because of my power supply fault. Power supply output is 24vdc, 5A and there is no potentiometer to regulate output voltage. strangely output voltage is reduced to 18VDC. I changed power supply and now logo is running normally
Osman_ Posts: 243 Rating: (4)
Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users umencho O_Moderator

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on