Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Monitoring timers in ladder what is x#(00 00 00 00) and can i change it?

Created by: rico100 at: 2/8/2013 9:42 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

2/8/2013 9:42 AM	Rate (0)
rico100 Experienced Member Joined: 10/14/2010 Last visit: 12/12/2025 Posts: 59 Rating: (3)	Hi, Could anyone tell me what the X#(00 00 00 00) means above the timer? It does increment as the timer is running so I'm assuming its the current running time in Hex? Is it possible to change the format? and what dows the X represent? Thanks in advance! Rich

Suggestion To thank Quote Answer

2/8/2013 4:01 PM	Rate (0)
Denilson Pegaia Diamond Expert Joined: 9/23/2005 Last visit: 1/12/2026 Posts: 4444 Rating: (1487)	Hi, can you send a printscreen of it?
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

2/8/2013 5:06 PM	Rate (0)
rico100 Experienced Member Joined: 10/14/2010 Last visit: 12/12/2025 Posts: 59 Rating: (3)	Hi, Thanks for the reply. I've attached a copy of a screen shot whilst monitoring a timer in an S7-1200. Attachment Capture.JPG (443 Downloads)

Suggestion To thank Quote Answer

2/28/2013 6:35 PM	Rate (0)
FreakOnALeash Posts: 267 Rating: (24)	Hello, I think this is the elapsed time in a special format. You can use the output "ET" to see it as time format.
FreakOnALeash Posts: 267 Rating: (24)
Suggestion To thank Quote Answer

2/28/2013 6:46 PM	Rate (0)
hdhosseini Diamond Expert Joined: 1/28/2009 Last visit: 1/5/2026 Posts: 6892 Rating: (1368)	rico100 Hi, Thanks for the reply. I've attached a copy of a screen shot whilst monitoring a timer in an S7-1200. Hello, What do you think about TIME variable in HEX representation? That should be checked for verification! Best regards Hamid Hosseini
	Demo Channel on Youtube
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on