Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Step 7 5.4 SP1

Created by: Martins at: 6/4/2007 4:51 PM (5 Replies)

Rating (2)

Thanks 0

6 Entries

6/4/2007 4:51 PM	Rate (0)
Martins Posts: 2 Rating: (1)	Hi, I have Reccently up graded from Step 7 5.3 +HF 4 to Step 7 5.4 SP1. Since I have upgrade I have not been able to view Actual values in the data block Data view only initial values. Best regards Matin
Martins Posts: 2 Rating: (1)
Suggestion To thank Quote Answer

6/4/2007 9:50 PM	Rate (0)
Late Platinum Member Joined: 1/7/2006 Last visit: 5/11/2025 Posts: 2705 Rating: (321)	Hi Martin, Have you tried to switch to the other mode in the VIEW in the editor ? There it must be possible, when not then the upgrade was not good Clear then everything and dirctly place S7 V5.4 SP2 on your system, that must come on internet in some days.
	I hope that the answer will help, if you have still questions, don't hesitate to ask me. All the best, Late Never say never, think in solutions, not in trouble......
Suggestion To thank Quote Answer

6/5/2007 9:45 AM	Rate (1)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 1/9/2026 Posts: 9104 Rating: (1202)	Hello Martin, Have you seen this faq: http://support.automation.siemens.com/WW/view/en/16719968 it's about restoring the 'Current value' column in Data view. Best regards, Wizard

Suggestion To thank Quote Answer

6/5/2007 11:11 AM	Rate (1)
Martins Posts: 2 Rating: (1)	Hi Many thanks for the replies the changing the zoom worked to restore the Actual value column in the data View. Best Regards Martin
Martins Posts: 2 Rating: (1)
Suggestion To thank Quote Answer

6/5/2007 11:50 AM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 1/9/2026 Posts: 9104 Rating: (1202)	Hello Martin, I'm glad it all worked now. Thank you very much giving us some feedback. Best regards, Wizard

Suggestion To thank Quote Answer

6/5/2007 6:40 PM	Rate (0)
Late Platinum Member Joined: 1/7/2006 Last visit: 5/11/2025 Posts: 2705 Rating: (321)	Hi Martin, Thank you for the reply, so Wizard have find a FAQ about it that solve the problem. It is realy a wizard...
	I hope that the answer will help, if you have still questions, don't hesitate to ask me. All the best, Late Never say never, think in solutions, not in trouble......
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on