Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Humidity sensor

Created by: acik at: 4/18/2013 12:32 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

4/18/2013 12:32 AM	Rate (0)
acik Posts: 12 Rating: (0)	I need a humidity sensor to connect to my BA6 Logo. Any suggestions ?
acik Posts: 12 Rating: (0)	Last edited by: acik at: 4/18/2013 12:33 AM
Suggestion To thank Quote Answer

4/18/2013 9:06 AM	Rate (0)
Toeternietoe Platinum Member Joined: 12/27/2006 Last visit: 11/17/2025 Posts: 1200 Rating: (116)	Yes, a lot of ideas. I like the red one. If u use a DC LOGO (LOGO! 12/24...) u can use the Analog input on the LOGO!, otherwise use an analog extension (type AM2) unit to your LOGO! An sensor with an 0 (2) - 10 Volts output can directley connected to the basic LOGO! An sensoir with 0(4) - 20 mA output can directly connected to an analog extensionunit, or with a resistror of 500 Ohms, you can connect it to the basic LOGO!
	Last edited by: Toeternietoe at: 4/18/2013 9:13 AM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on