Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Global Data Blocks - Syntax to adress BOOLEAN flags of DWORD

Created by: BITS AND BYTES at: 6/5/2013 2:52 AM (2 Replies)

Rating (0)

Thanks 1

3 Entries

6/5/2013 2:52 AM	Rate (0)
BITS AND BYTES Posts: 8 Rating: (9)	Trying to create a global data block consisting of a DWORD and all its 32 associated BOOLEAN bits. What is the syntax required to address each bit of the DWORD in a DATA BLOCK. Do not want to create a BOOLEAN ARRAY since it is not possible to add a comments to each BOOLEAN flag. Suggestions please. Attachment Data Block.JPG (470 Downloads)
BITS AND BYTES Posts: 8 Rating: (9)	Last edited by: BITS AND BYTES at: 6/5/2013 2:52 AM
Suggestion To thank Quote Answer

6/5/2013 8:56 AM	Rate (0)
Kamel0 Experienced Member Joined: 3/28/2011 Last visit: 8/13/2025 Posts: 4 Rating: (0)	Hi, Is this what You looking for? https://support.automation.siemens.com/WW/llisapi.dll?func=cslib.csinfo&objId=57374719&load=treecontent&lang=en&siteid=cseus&aktprim=0&objaction=csview&extranet=standard&viewreg=WW Best regards, Kamil

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Tomy Master

6/5/2013 9:40 AM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 1/15/2026 Posts: 9105 Rating: (1204)	Hello BITS AND BYTES, The global datablock is an optimized datablock? Best regards, Wizard

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on