Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Program Execution Problem

Created by: Anjum786 at: 7/9/2013 7:10 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

7/9/2013 7:10 AM	Rate (0)
Anjum786 Posts: 21 Rating: (0)	Hi, I have recently upgraded my Simodrive DC Main Spindle Drive to Sinamics DC DCM Main Spindle drive. Machine is working properly in Milling mode but it is not working properly in Turning Mode. After achieving given rpm, Controller in not reading next block in auto mode. Suggest me the proper configuration of Sinamics Drive with Sinumerik 840C Controller to work properly in turning mode alongwith next block reading problem.
Anjum786 Posts: 21 Rating: (0)
Suggestion To thank

7/9/2013 1:07 PM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 1/9/2026 Posts: 4114 Rating: (195)	closed cause question posted twice. The second thread with the subject Program Execution Problemis published within the conference SINAMICS. Best regards CS Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on