Navigation

SYSTEM TIME OF KTP600 HMI with TIA V11

Created by: LetiCir at: 8/1/2013 10:39 PM (1 Replies)

8/1/2013 10:39 PM	Rate (0)
LetiCir Posts: 1 Rating: (0)	Thavas For KTP600 PN Devices you have to configure area pointer (Date time PLC) from winCC, then you can see the exact system time,this value is fetched from PLC on regular intervals. if area pointer is not configured then the device will show default time start from 1/01/2004 Because this device does'nt have clock functionality like other multipanels (MP277) Can you explain me how to do this in the Tia Portal v11? I have the same problem. I'm using a CPU1214C with a KTP600 and I don't know how to change system time. 2004 is the date displayed. Thank you very much
LetiCir Posts: 1 Rating: (0)	Last edited by: O_Moderator at: 8/2/2013 12:39 PM new subject after splitting from /tf/WW/en/Posts/42214#top
Suggestion To thank Quote Answer

8/2/2013 8:57 AM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 12/24/2025 Posts: 9097 Rating: (1202)	LetiCir Can you explain me how to do this in the Tia Portal v11? I have the same problem. I'm using a CPU1214C with a KTP600 and I don't know how to change system time. 2004 is the date displayed. Thank you very much Hello LetiCir, Please have a look at this link: how do you synchronize the time of the HMI Basic Panel with an S7-1200 PLC? It's important to use the Area Pointer "Date/Time" (This will change the System time) Best regards, Wizard

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users pakplc