Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

WinCC Flex and WinCC V 6.0 together

Created by: Pravin007 at: 12/4/2005 2:26 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

12/4/2005 2:26 PM	Rate (0)
Pravin007 Posts: 15 Rating: (0)	Hello, I have a singlePC and I want to run WinCC Flex and WinCC V6.0 on that system. Is it possible to run the WinCC Flex and WinCC V 6.0 on same system?[:o] If yes, then anycare reuired during installation. If no, then why is it not possible? Pravin
Pravin007 Posts: 15 Rating: (0)
Suggestion To thank Quote Answer

12/5/2005 9:17 AM	Rate (0)
The Brain Posts: 1611 Rating: (121)	Hallo Pravin007, please check the following FAQ => http://support.automation.siemens.com/WW/view/en/22056585
The Brain Posts: 1611 Rating: (121)
Suggestion To thank Quote Answer

12/8/2005 9:07 AM	Rate (0)
Pravin007 Posts: 15 Rating: (0)	Hello, Thank You for Reply, I gone through the FAQ that you had send. But I have WinCC V6.0 SP2 and nat SP3. Can Iuse WinCC V6.0 SP2and WinCC Flex Together? Please send reply. Pravin007
Pravin007 Posts: 15 Rating: (0)
Suggestion To thank Quote Answer

12/8/2005 1:18 PM	Rate (0)
The Brain Posts: 1611 Rating: (121)	Hello, normelly, in the FAQ there are the min. condition. So you need WinCC V6.0 SP3. You can make an image from your PC. After then you try to install both software. When you get a "cresh" you installyour image to the PC. I think, this will be the best.
The Brain Posts: 1611 Rating: (121)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on