Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

STL help!

Created by: Per Olof at: 3/27/2014 9:28 AM (5 Replies)

Rating (0)

Thanks 0

6 Entries

3/27/2014 9:28 AM	Rate (0)
Per Olof Posts: 311 Rating: (3)	Hello, I need some help ... How do I write this in STL. if (test1 > 10) and (test1 <= 15) Then End if This is not correct, what is the correct way to write it ? L #test1 L 10 >R A L #test1 L 15 <=R = #test2 Regards Per Olof
Per Olof Posts: 311 Rating: (3)	Last edited by: Per Olof at: 3/27/2014 9:47 AM
Suggestion To thank Quote Answer

3/27/2014 9:58 AM	Rate (0)
crazyCow Gold Member Joined: 12/4/2009 Last visit: 11/6/2025 Posts: 453 Rating: (137)	Olof, I do not think You code would perform well. Why not try something like this: A( L #test01 L 10.0 > R ) A( TAK L 15.0 <= R ) JCN A001 = #test02 JU A002 A001:CLR = #test02 A002: NOP 0 Hope this helps. Regards.
	If this post actually helped, you may consider using the Rate button above.
Suggestion To thank Quote Answer

3/27/2014 10:02 AM	Rate (0)
Per Olof Posts: 311 Rating: (3)	Thanks crazyCow
Per Olof Posts: 311 Rating: (3)
Suggestion To thank Quote Answer

3/27/2014 12:34 PM	Rate (0)
TomDeWou Platinum Member Joined: 11/15/2006 Last visit: 3/26/2025 Posts: 1319 Rating: (176)	If you do not know how to do in STL use FBD block and switch to STL afterwards
	Have Fun! TomDeWou
Suggestion To thank Quote Answer

3/27/2014 2:50 PM	Rate (0)
0_Einstein Grandmaster-Expert Joined: 7/7/2010 Last visit: 12/31/2025 Posts: 16342 Rating: (2521)	TomDeWou If you do not know how to do in STL use FBD block and switch to STL afterwards Which PLC(s) does this technique work and what versions of the portal? I am using just the s7-1200's and can only switch between FBD/LAD. Is S7-1200 in V13 using STL now ? ;) That would be nice.
	science guy
Suggestion To thank Quote Answer

3/31/2014 3:58 PM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 10/31/2025 Posts: 4114 Rating: (195)	follow up question published by Per Olofis split to a seperate thread with the subject STL help! - IN :=NOT #On Best regards CS Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on