Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Checking system

Created by: Lupenquarto at: 4/1/2014 5:18 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

4/1/2014 5:18 AM	Rate (0)
Lupenquarto Posts: 1 Rating: (0)	Dear all, I am a wiring harness producer, and i would to use LOGO system to check the my production, now i explain better: I have the necessity to test if the point A is connected with point B, and for examplenot with point C The test is a verify of wire presence and exactly position. The final result could be a lamp that if everything is correct became green if there is a proble is red The total n° of point to test is included from 2 to 192 Is possible to realize this operation with LOGO?? Thank you
Lupenquarto Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

4/1/2014 5:09 PM	Rate (0)
Ste39 Posts: 4620 Rating: (710)	Hi Lupenquarto, mmmmhhh I do not know if some of our friends of this forum will give you a solution also because you have to check 192 points simultaneously? take a look at how many inputs you have available: What is the maximum number of inputs and outputs that can be addressed on the LOGO!? I rather think that there is some kind of instrument which will do this job, or you've already looked in that direction? Only for suggestion: easy-wire Harness Test System (Harness Tester/Cable Tester)
Ste39 Posts: 4620 Rating: (710)	Last edited by: Ste39 at: 4/1/2014 5:13 PM
Suggestion To thank Quote Answer

4/7/2014 5:31 PM	Rate (0)
allmächt! Posts: 215 Rating: (6)	Hi Lupenquarto, is it possible to post more details? Which way are you going to checkthe the connection? regards
allmächt! Posts: 215 Rating: (6)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on