Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Connention cable for CP5512

Created by: adepietri at: 10/8/2007 11:57 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

10/8/2007 11:57 AM	Rate (0)
adepietri Posts: 2 Rating: (0)	For connect theCP5512 to Profibus network, what are the features of the cable between the adapter and the PLC or passive device like ET200 etc. Can i used pin-to-pin cable? Sorry for my English, thank you.
adepietri Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

10/8/2007 1:44 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 7/31/2025 Posts: 9027 Rating: (1199)	Hi, It's a Profibus cable. Use the profibus connectors to make a cable. Best regards, Wizard

Suggestion To thank Quote Answer

10/8/2007 2:33 PM	Rate (0)
dchartier Grandmaster-Expert Joined: 9/27/2006 Last visit: 9/3/2025 Posts: 12397 Rating: (2717)	Hello adepietri; Profibus cable and connectors will work very well, but you may choose to use a straight pin-to-pin cable if you have it. If you need to build it, simply make sure you connect the 3 RS-485 standard pins on syour Sub-D 9 pin connectors: 3-->3 8-->8 5-->5 For short distances, under 5 m, termination and shielding should not be an issue. For longer distances the Profibus cable and connectors would be a better solution. Hope this helps, Daniel Chartier

Suggestion To thank Quote Answer

10/9/2007 12:01 AM	Rate (0)
J_Bell Posts: 5822 Rating: (412)	Hello, I would also, like Wizard said, strongly recommend to use a PROFIBUS Cable with PROFIBUS Plugs because as soon as you try to use higher Baudrates you will risk the Hardware you use. The use of a "simple" cable can lead to this point that the Nodes on the bus will be damaged. Best regards J_Bell
J_Bell Posts: 5822 Rating: (412)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on