Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Rewind torque controller

Created by: allan1003 at: 5/27/2011 12:03 PM (5 Replies)

Rating (0)

Thanks 0

6 Entries

5/27/2011 12:03 PM	Rate (0)
allan1003 Posts: 15 Rating: (0)	Hi, Can anyone help please, I would like to use a Logo to control the tension of a centre winder. The initial torque would be set by a potentiometer (0-10 volt) or could be set on a Logo TD, a second analog input would be from an ultrasonic transducer measuring roll diameter. As the roll diameter increasesI want the torque to increase. The output into a DC drive would be 0-10 Volts. Thanks Allan
allan1003 Posts: 15 Rating: (0)
Suggestion To thank Quote Answer

5/27/2011 12:41 PM	Rate (0)
Toeternietoe Platinum Member Joined: 12/27/2006 Last visit: 11/17/2025 Posts: 1200 Rating: (116)	I have made a simple programm. Is only the start of your wishes. Succes Attachment torck-control.zip (343 Downloads)

Suggestion To thank Quote Answer

5/27/2011 12:49 PM	Rate (0)
Marcjan Diamond Member Joined: 4/22/2010 Last visit: 3/31/2025 Posts: 5697 Rating: (716)	One important thing to know is: does the value from sensor decrease or increase if diameter off the rol gets bigger ? There are generally 3 types off us sensors, one dat increases the value when getting closer, one that decreases the value and som that can be setup to do both. Best regards, Marcjan
	Problem solved? Please let us know! Please no technical questions by PM, use the forum sections for your questions.
Suggestion To thank Quote Answer

5/27/2011 1:00 PM	Rate (0)
allan1003 Posts: 15 Rating: (0)	Hi, The value increases. Thanks Allan
allan1003 Posts: 15 Rating: (0)
Suggestion To thank Quote Answer

5/27/2011 2:59 PM	Rate (0)
Marcjan Diamond Member Joined: 4/22/2010 Last visit: 3/31/2025 Posts: 5697 Rating: (716)	O.k. Then the example should work fine. Best regards, Marcjan
	Problem solved? Please let us know! Please no technical questions by PM, use the forum sections for your questions.
Suggestion To thank Quote Answer

7/31/2014 10:28 AM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 1/9/2026 Posts: 4114 Rating: (195)	new question published by Mark Hupertzis split to a seperate thread with the subjecttorque controller - how can I control the speed and torque. Best regards CS Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on