Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Creating a new file?

Created by: Cameo at: 10/16/2007 7:09 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

10/16/2007 7:09 PM	Rate (0)
Cameo Posts: 2 Rating: (0)	Hello ,I am mechanical engineer who is learning S5 and i have been happy monitering and making small changes .recently we lost a program and our newest backup failed .we used an old program to get things running .The original programmer sent me the files for the latest alterationsbut there are about ten of them. I put the pj ini file into the old backup folder and the blocks appear to be be there .When i transfer them though the program has several address errors.I went to the settings page and loaded a zo file but no joy .Can anyone tell me how to create a new file with all these files?Help would be much appreciated as following the manual is getting tiresome and not always relevany to my version 6.6 software.
Cameo Posts: 2 Rating: (0)	Last edited by: Cameo at: 16.10.2007 19:10
Suggestion To thank Quote Answer

10/18/2007 11:45 PM	Rate (0)
Late Platinum Member Joined: 1/7/2006 Last visit: 5/11/2025 Posts: 2705 Rating: (321)	Cameo I put the pj ini file into the old backup folder and the blocks appear to be be there .When i transfer them though the program has several address errors. I went to the settings page and loaded a zo file but no joy .Can anyone tell me how to create a new file with all these files? Hi, The pj-file is a project-file, but because you have V6.6 that won't help, the pj-file was not yet used when the V6.6 was actual (last age). The z0-file belongs to the symbolik and can't be used.... You need the ST-file, that is the program that must be loaded to the S5 CPU... I don't know anymore how V6.6 looks, but there must be somewhere a field where you can choose for the ST-file. When that is ready you have to go online and then send the blocks to the CPU.
	I hope that the answer will help, if you have still questions, don't hesitate to ask me. All the best, Late Never say never, think in solutions, not in trouble......
Suggestion To thank Quote Answer

10/19/2007 8:29 PM	Rate (0)
Cameo Posts: 2 Rating: (0)	Thanks for the reply i was beginning to loose hope .I am at work tomorrow and will hopefully sort it out.
Cameo Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on