Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

CPU 115 & closed loop controller(6ES5 252-3AA13)

Created by: ambrish at: 10/31/2007 8:33 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

10/31/2007 8:33 AM	Rate (0)
ambrish Bronze Member Joined: 11/8/2006 Last visit: 8/3/2025 Posts: 57 Rating: (4)	Dear All In one of our s5 system, CPU 944 816-1AA11 is the CPU & there is also a closed loop controller(6ES5 252-3AA13). CPU & above mentioned closed loop controller is inSTOP mode.If I perform an overall reset ,CPU will go to RUN mode ,but at this time also,closed loop controller is in STOP mode.After overall reset,if I download programme ,CPU will go to STOP mode again . What can be the problem? What is the normal conditions for closed loop controller to go in RUN?There is a PG/PC port on closed loop controller.To communicate with this card thru PG,do I need any software other than s5? Thanks Ambrish.
	Last edited by: ambrish at: 31.10.2007 09:07 NB: In ISTAK control Bit Disply, STOZUS & STOANZ are marked.
Suggestion To thank Quote Answer

11/1/2007 7:39 PM	Rate (0)
J_Bell Posts: 5822 Rating: (412)	Hello, have you checked what the COM REG for the IP 252 says? Software Archive: COM REG V1.0 (A04) Best regards J_Bell
J_Bell Posts: 5822 Rating: (412)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on