Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Simulation with Portal V13

Created by: Osld13 at: 12/19/2014 4:10 PM (2 Replies)

Rating (0)

Thanks 1

3 Entries

12/19/2014 4:10 PM	Rate (0)
Osld13 Experienced Member Joined: 3/20/2012 Last visit: 1/9/2026 Posts: 120 Rating: (1)	Hi everybody, With Portal i can simulate A plc, and an HMI, but i can't make the simulated HMI communicate with a real S7-1500...Is it the same for you? Best regards.

Suggestion To thank Quote Answer

12/19/2014 4:16 PM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 12/19/2025 Posts: 22816 Rating: (3073)	Hi, this is possible. The only thing you must do is set in Windows Control Panel -> PG/PC Interface the Access Point S7ONLINE to the Interface(PROFIBUS/ETHERNET) which you have configured in TIA for the online connection of the HMI and which is connected to the PLC. Regards Christoph
	Last edited by: ChristophD at: 12/19/2014 4:17 PM
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users not_my_fault

12/19/2014 6:33 PM	Rate (0)
Osld13 Experienced Member Joined: 3/20/2012 Last visit: 1/9/2026 Posts: 120 Rating: (1)	Tanks ChristophD, I'm going to try that. It sounds likely. Nice Christmas to all. Olivier.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on