Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Questions about analog outputs

Created by: Suanya at: 1/1/2015 8:48 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

1/1/2015 8:48 PM	Rate (0)
Suanya Posts: 15 Rating: (0)	Hi all I'm trying to make a program logo8 to regulate 3 drive with a setpoint of exterior drive , and 1 Danzer regulation for each drive That happens in the output of AQ when gets a negative value, in my case at most is -30 If you could do some improvement, would be delighted to help Sorry for my English Attachment Driver speed_1.zip (330 Downloads)
Suanya Posts: 15 Rating: (0)	Last edited by: Suanya at: 1/1/2015 9:49 PM
Suggestion To thank Quote Answer

1/1/2015 9:40 PM	Rate (0)
ixo65 Grandmaster Joined: 12/18/2014 Last visit: 1/9/2026 Posts: 36421 Rating: (4547)	The logo can't issue negative values to analog Outputs.

Suggestion To thank Quote Answer

1/1/2015 9:53 PM	Rate (0)
Suanya Posts: 15 Rating: (0)	From the value 0 to -30 the effective output is 0v? The logo does not give any errors Had forgotten to upload the project
Suanya Posts: 15 Rating: (0)
Suggestion To thank Quote Answer

1/1/2015 10:06 PM	Rate (0)
ixo65 Grandmaster Joined: 12/18/2014 Last visit: 1/9/2026 Posts: 36421 Rating: (4547)	No, the logo does not issue error. they can only 0-10V or 0 / 4-20maA spend.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on