For example I want to start Step7 with FC10 Network 8 from a windows application ? the example in step7 manual does't work.

Starting STEP 7 with Default Start Parameters

From STEP 7 V5.0 onwards, you can create several symbols in the SIMATIC Manager and specify start parameters in the callline. By doing this, you can cause the SIMATIC Manager to position on the object described by these parameters. This allows you to jump to the corresponding locations in a project immediately just by double-clicking.

On callings7tgtopx.exe, you can specify the following start parameters:

/e<complete physical project path>

/o<logical path of the object on which you want to position>

/h<ObjectID>

/onl

The start parameter /onlcauses the project to be opened online and the specified path to be called.

/off

The start parameter /offcauses the project to be opened offline and the specified path to be called.

/keep

The start parameter /keep causes the following to occur:

If the SIMATIC Manager is open, the already displayed projects are opened in addition to the new project to be explicitly opened by means of thecommand line. If the SIMATIC Manager is not yet open, then the new project is opened along with the projects stored in the session memory of the SIMATIC Manager. If this start parameter is not specified, the opened projects are closed first, the session memory is ignored and only the one specified project is opened.

/noopen

The start parameter /noopencauses no project to be opened when SIMATIC Manager is started.

The easiest way to establish suitable parameters is described below.

Establishing Parameters by Copying and Pasting

Proceed as follows:

1. On your desktop, create a new link to the file s7tgtopx.exe. This file is located in the installation directory under S7bin.

2. Display the properties dialog box.

3. Select the "Link" tab. The entry under "Target" should now be expanded as follows.

4. Select the required object in the SIMATIC Manager.

5. Copy the object to the clipboard using the key combination CTRL+ALT+C.

6. Position the cursor at the end of the "Target" entry in the "Link" tab.

7. Paste the contents of the clipboard using the key combination CTRL+V.

8. Close the dialog box by confirming with "OK."

Example of Parameters:

/e F:\SIEMENS\STEP7\S7proj\MyConfig\MyConfig.s7p /keep

/o "1,8:MyConfig\SIMATIC 400(1)\CPU416-1\S7-Program(1)\Blocks\FB1"

/h T00112001;129;T00116001;1;T00116101;16e /keep

Hello 

You Can find the following link

MAZENJER

Hello 

You Can find the following link

 Dear MAZENJER, where is the link ?