Default Header
(header konnte nicht geladen werden)
Navigation
Can't find 6ES7138-4FA05-0ab0 in Step7 HW Catalog
Created by: Msorich at: 10/30/2018 12:47 PM (7 Replies)
Rating 
Thanks 1
8 Entries
| 10/30/2018 1:14 PM | |
Joined: 11/15/2015 Last visit: 12/3/2025 Posts: 180 Rating:
|
Hello, To configure it as Safety I/O you will need the optional package S7-Distributed Safety.https://w3.siemens.com/mcms/simatic-controller-software/en/programming-options/distributed-safety-sw/pages/default.aspx Regards, ========================================================= Look for alternative not for the correct answer.... |
|
Look for alternative not for the correct answer...if this is helping you rate it. |
|
| 10/30/2018 1:31 PM | |
|
Posts: 661 Rating:
|
You didn't understand my question, I think. The Safety Distributed V5.4 SP5 itself was installed long ago. I just need some info about what I need to update to get in HW catalog these relatively new F-modules, e.g. 6ES7138-4FA05-0AB0. Msorich Update: I installed this latest HSP. latest HSP 09/2018 There' no needed modules there! |
Last edited by: Msorich at: 10/30/2018 2:04:27 PMLast edited by: Msorich at: 10/30/2018 2:05:14 PMLast edited by: Jen_Moderator at: 10/31/2018 8:40:26 AMOptimized link. |
|
| 10/30/2018 6:23 PM | |
Joined: 9/21/2012 Last visit: 1/1/2026 Posts: 4836 Rating:
|
Have you downloaded S7 F ConfigurationPack V5.5 SP13? When you install this, you should have all available modules in HW configuration. |
Last edited by: Jen_Moderator at: 10/31/2018 8:41:41 AMOptimized link. |
|
This contribution was helpful to
|
|
| 10/30/2018 6:42 PM | |
|
Posts: 661 Rating:
|
Yeah... An hour ago I downloaded that pack. Msorich |
| 11/7/2018 2:48 PM | |
|
Posts: 9 Rating:
|
Can you find a GSD file and install it into the STEP7 HW Config. |
Follow us on