Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

Multiprocessor configuration access

Created by: dkor at: 5/28/2019 4:41 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

5/28/2019 4:41 PM	Rate (0)
dkor Advanced Member Joined: 7/28/2007 Last visit: 9/7/2025 Posts: 29 Rating: (2)	Hello, I meet a situation with Simatic S5 PLC control system. There are located 3 CPU on the same central rack. The central rack configuration is 6ES5925-3KA12, 6ES5926-3KA12, 6ES5927-3KA13 6ES5511-5AA12 (communication card ), 6ES5350-3KA21 and 6ES5512-5BC12. I intend to be connected to CPU using the communication port of communication board for 6ES5511 wich has 25 pin connector, male type. I found some information that the port do not provide power for current loop communication. Therefore I intend to use an constant current adapter for communication with my laptop. I already have some experience with Simatic S5 PLC, but is my first time on that configuration. Please, can someone to guide me how to connect with that Simatic S5 PLC system. It will be usefull if I will get the documentation for 6ES5511 board also. Best regards. Attachment CPU.jpg (459 Downloads)

Suggestion To thank Quote Answer

6/21/2019 10:48 PM	Rate (0)
Pee Ell Sea Posts: 672 Rating: (57)	HI, Looks like a 150 plc to me not a multiprocessor. Look on this site for 511 cable connections there have been hundreds of posts over the years. Pee
Pee Ell Sea Posts: 672 Rating: (57)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on