Step 7 V5.4 unable to uplaod to PG

Hello everyone,

I am trying to upload a program from a 315-2 PN/DP. The program was written in Step 7 V5.5+SP1 and I have Step 7 V5.4+SP5 and I just updated all hardware configs. I can hook into the system over ethernet and see all accessable nodes but when I upload to PG I get two errors then Step 7 goes unresponsive and closes. The errors are both 13:77 the first is (3) and the second is (2004). It seems like v5.4 is not compatable with a v5.5 program but I thought it was. Any suggestions?

DylanPeterMiller

Hello everyone,

I am trying to upload a program from a 315-2 PN/DP. The program was written in Step 7 V5.5+SP1 and I have Step 7 V5.4+SP5 and I just updated all hardware configs. I can hook into the system over ethernet and see all accessable nodes but when I upload to PG I get two errors then Step 7 goes unresponsive and closes. The errors are both 13:77 the first is (3) and the second is (2004). It seems like v5.4 is not compatable with a v5.5 program but I thought it was. Any suggestions?

Hi

Can you send a screenshot of errors?

What is your exact configuration? Are you trying to upload directly from CPU or you using a CP module?

Hi,

The load that I am doing directly from the CPU by MPI sent you the error images. 

The CPU is: CPU319F-3 PN/DP

If you continue the process this other error comes out,

Thanks.

Actually I was expecting an english message.

But your problem is a common problem among Fail-safe CPUs and happens always and as far as know there is no solution.