Skip to Content

Register Login

Default Header

(header konnte nicht geladen werden)

Navigation

FB100 totalizer

Created by: Hasan1987 at: 7/6/2020 7:04 PM (4 Replies)

Rating (0)

Thanks 1

5 Entries

7/6/2020 7:04 PM	Rate (0)
Hasan1987 Posts: 93 Rating: (0)	Hi experts, In a project I tried to use FB100 totalizer from the following address but while I have observed all rules, the output of the totalizer is constantly 0. What is your idea? https://support.industry.siemens.com/cs/ww/en/view/23061633
Hasan1987 Posts: 93 Rating: (0)	Last edited by: Jen_Moderator at: 07/07/2020 09:14:44 Optimized link.
Suggestion To thank Quote Answer

7/10/2020 8:20 AM	Rate (0)
Willybong Silver Member Joined: 2/11/2015 Last visit: 1/8/2026 Posts: 515 Rating: (36)	Hi Hasan 1987, Did you put the block on OB1?¿ Maybe you could try changing cycle to T#1s Pay attention that the RESET input is not SET.

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users qwazee

10/2/2020 10:44 AM	Rate (0)
Hasan1987 Posts: 93 Rating: (0)	yes I did all of them
Hasan1987 Posts: 93 Rating: (0)
Suggestion To thank Quote Answer

10/2/2020 12:56 PM	Rate (0)
dchartier Grandmaster-Expert Joined: 9/27/2006 Last visit: 1/16/2026 Posts: 12481 Rating: (2722)	Hello Hassan; I used this block in various programs we developped with Step 7 v5.x. It always provided acceptable results if: - the block was called in OB 35 (cyclic interrupt) - the parameter Cycle of the integrator block was set at the same value as the cycle setting of OB 35 (or at a multiple of that value). See for example the contents of the following discussion: https://support.industry.siemens.com/tf//ww/en/posts/totalizer-block-for-4-flow-meters/66519/?page=0&pageSize=10 Could you show us your code for your block, preferably the online version? Hope this helps, Daniel Chartier
	Last edited by: dchartier at: 10/02/2020 17:28:41
Suggestion To thank Quote Answer

10/16/2020 9:49 AM	Rate (0)
Hasan1987 Posts: 93 Rating: (0)	I set all parameters correctly but no result! unfortunately I had to use my own logic but in the future I will use it in another project and I will inform you
Hasan1987 Posts: 93 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on