Hi,

I would like to communicate with a C600 Elau Pacdrive controller and a S7-317 2 DP controller

I try to used the GSD : EC1-DEB-DPS (hil_06e7.gsd) version 1.000

In the parameter:

Just change the node to 14.

DPV1 is disable.

It communicated at 12 mb

I put the adresse IN and OUT with word, for test only one word IN, one word Out.

In ELau C600.

Pacdrive V24.

I used the same GSD with ELAU V24.

I put the GSD in the Slave Profibus and put the same node adress: 14

The configuration is the same: one word input con and one word output con with the same adress.

The two PLC now is green and run.

I think the PLC siemens see the PLC ELau, but otherside the Elau dont see the Siemens. When i cut the hardware communication the PLC siemens change to red light but not the ELAU... i think it communicate 

Thanks

Alain

Could you please help me to Ethernet communication from PLC SIEMENS to ELAU plc through CP card ?

New question published by ALBERTO SGA is split to a separate thread with the subject ELAU controller C200 GSD.

Best regards
Min_Moderator