Hi there, 

I am having a problem with touchscreen/TS (KTP 700 Basic 2nd generation). I had connected ethernet cable from the TS to Scalance XB005 and another cable from laptop to Scalance XB005. I was doing doing a pint test since earlier there was problem when the it was running networked to a PLC. There was no issue in the beginning of the ping test, After almost an hour the ping was not successful (intermittent connection). I had tried changing the cable, port & also tried making direct connection to the laptop. After few hours into the test, the TS screen only displayed black & white lines & the ping result returned time out continuously. Then i tried to power OFF & ON the TS and tried again (where there onwards the display returned normal but the connection was still intermittent). The TS had 13.00.00.04_01.01 as the image version & the boot loader version date was display June/July 2016. Is there any fix for these?

New question published by EfrenCC is split to a separate thread with the subject KTP700 Basic is blocked or inhibited.

Best regards
Min_Moderator

Hey,

i am not shure what your problem are. Did you have problem to connect the panel via ethernet or does not the panel start?

At first. Check your "PG/PC Interface" (Windows PC > Control Panel). Under "Access Point" there should adjusted  "S7ONLINE -> Your Ethernet adapter".

As next. Make  a set up to "Reset to factory settings".

https://support.industry.siemens.com/cs/ww/en/view/19701610

Good look!

Hi,

did you have try to make a reset to factory settings?
Use ProSave (i mean this is the best) use any ip-address an put the mac-address into the address field (you find it on the back side from the panel) activate the check box "reset to factory" and reboot the panel. This should be work.

regards