SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Speed Controller Optimization/Automatic Controller setting S120

7/27/2012 7:57 PM	Rate (0)
monir Posts: 37 Rating: (0)	I am new to sinamics S120. I have 2 questions regarding measurment: Could anyone tell me when perform speed controller optimization for Sinamics S120 that time motor will run or not ?If run how long it will run ? Similarly when perform Automatic Controller setting that time motor will run or not ? If run how long it will run ? Your reply will be great help.
monir Posts: 37 Rating: (0)
Suggestion To thank Quote Answer

7/30/2012 9:15 AM	Rate (0)
Fatso Posts: 168 Rating: (6)	Hi I have not timed it but it takes a few minutes(less than five in my experience) and the motor will rotate,it might even reach maximium speed.
Fatso Posts: 168 Rating: (6)
Suggestion To thank Quote Answer

7/31/2012 2:39 PM	Rate (0)
DavidBrown Posts: 975 Rating: (9)	My experience is that during automatic controller setting the motor shaft turns about +- 5 revolutions. In my case where there was a gearbox of 1/20, so the chasis hardly moved.
DavidBrown Posts: 975 Rating: (9)
Suggestion To thank Quote Answer

10/30/2015 12:37 PM	Rate (0)
Min_Moderator Posts: 4757 Rating: (122)	New question published by mjrv is split to a separate thread with the subject Perform Automatic controller settings. Best regards Min_Moderator
Min_Moderator Posts: 4757 Rating: (122)
Suggestion To thank Quote Answer

Share this page:

Share this page on...