Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

ProTool V6.0 SP3 Installation Error

Created by: AnoopKP at: 8/11/2011 8:56 AM (6 Replies)

Rating (5)

Thanks 8

7 Entries

8/11/2011 8:56 AM	Rate (0)
AnoopKP Posts: 7 Rating: (0)	Dear Guys, I am facing an error during the installation of ProToool V 6.0 SP3 version as shown below. and i have attached a screen shot of the same. " An error had occured during installation. Error No:- 115" I am using a Windows XP SP3 Version pls let me know any of you have experienced with this error. Thanks in Advance Anoop.K.P Attachment Error.JPG (1311 Downloads)
AnoopKP Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

8/11/2011 10:03 AM	Rate (0)
The Brain Gold Member Joined: 10/19/2005 Last visit: 11/30/2020 Posts: 1611 Rating: (121)	Hi, which Windows operating systems have you installed? -> http://support.automation.siemens.com/WW/view/en/8795248 Deactivate during installation your "antivir" program regards,

Suggestion To thank Quote Answer

8/11/2011 12:11 PM	Rate (2)
Zenta Silver Member Joined: 10/12/2006 Last visit: 10/29/2024 Posts: 206 Rating: (25)	Hi, what is your installation path? Do you try install Protool from hard disk? or CD? Regards Zenta

Suggestion To thank Quote Answer

8/11/2011 1:43 PM	Rate (0)
AnoopKP Posts: 7 Rating: (0)	From Hard disk. I have done the same thing on another desktop it is working fine.
AnoopKP Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

8/12/2011 2:09 PM	Rate (1)
Zenta Silver Member Joined: 10/12/2006 Last visit: 10/29/2024 Posts: 206 Rating: (25)	Hi, sometime if the path is too deep, the installation is stopped with error, try copy the install directory to c:\ or d:\... Maybe after than you can install. Regards Zenta

Suggestion To thank Quote Answer
This contribution was helpful to 4 thankful Users master_reset 29a Rene Kostolnik-Linde fellskev Brebiou88

12/1/2011 5:49 PM	Rate (2)
master_reset 29a Posts: 6 Rating: (11)	Hi, got the same problem, installation shuting down after message "Unable to launch ServicePack 3" only ProTool V6.0 without SP3 was installed. Then I copied the Installationfiles direkt to C: and the Installation was completed successfully Tested the Intergation in Step7 --> WORKS Tested without Integration --> WORKS thx Zenta
master_reset 29a Posts: 6 Rating: (11)
Suggestion To thank Quote Answer
This contribution was helpful to 4 thankful Users Rene Kostolnik-Linde KhanhLe GREXOR Brebiou88

4/20/2016 11:12 AM
markusturk Posts: 2 Rating: (0)	Zenta thanks 1000x, it works for me also.
markusturk Posts: 2 Rating: (0)
Suggestion Quote Answer

|

Share this page:

Share this page on...

Follow us on