Hi Billel11

Maybe some components were not uninstalled properly. Check the below link, may be of some use.

https://support.industry.siemens.com/cs/ru/en/view/14618173

Hope this helps!

#dP

Hello.

Some pieces of the old program is still there. You have to manually delete those files if you have done a proper uninstall of the previous version. You should find it under C:\Program Files (x86).

Regards.

 I did that but the problem persists.

Prassanna G

Hi Billel11

Maybe some components were not uninstalled properly. Check the below link, may be of some use.

https://support.industry.siemens.com/cs/ru/en/view/14618173

Hope this helps!

I do it too but I don't found the folder appropriate to delete it

Hello,

my sequence was helpful to me when some similar problem occured (in some cases be carefuly in regedit):

1. check and delete manually from disk where is your interrupted Microwin located.

2. run regedit and set find for Microwin, carefully delete all what you'll find.

3. run CCleaner and execute both checks. after all set to delete all finded problems with register.

4. restart PC.

Run your instalation with Admin rights.