SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Does the Technology CPu 317T supports the sinamics G150?

7/6/2009 10:20 PM	Rate (0)
arlettebaes Posts: 5 Rating: (0)	Does the Technology CPu 317T supports the sinamics G150? I would like to connect it directly to the DP Drive port. If it isn't possible, why not?
arlettebaes Posts: 5 Rating: (0)	Last edited by: CS Moderator at: 7/7/2009 8:56 AM new subject after splitting
Suggestion To thank Quote Answer

7/7/2009 6:05 AM	Rate (0)
umencho Grandmaster Joined: 3/21/2006 Last visit: 12/31/2025 Posts: 10238 Rating: (1183)	Hello, Yes, you can connect G150 to profibus network. PROFIBUS DP(DRIVE) – Connection of drive components The technology controllers have an isochronous DP(DRIVE) interface for connecting the drive components. This is optimized for connection of drives over PROFIBUS – all Siemens drives are supported. But, Supported components for technology functions on PROFIBUS DP(DRIVE) Speed axes MICROMASTER 420/430/440 COMBIMASTER 411 SIMOVERT MASTERDRIVES VC Positioning/synchronized axes SIMODRIVE 611 universal HR SIMOVERT MASTERDRIVES MC SIMODRIVE POSMO CD/SI/CA SINAMICS S 120 Other PROFIBUS nodes SIMODRIVE sensor isochronous ADI 4 analog drive interface module IM 174 ET 200M with IM 153-2 High Feature ET 200S with IM-151-1 High Feature More info at Technology controller Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

7/7/2009 11:04 AM	Rate (0)
miami Platinum Member Joined: 8/31/2005 Last visit: 12/16/2025 Posts: 2198 Rating: (331)	You can use the SINAMICS G150 as a speed controlled axis,but not as a position controlled axis. The CU of the SINAMICS G150 does not offer the required functions (no iscocron PROFIBUS, no encoder interface with position information) When you use a IM174 you can use any drive with a T-CPU. The IM174 will give a +- 10V setpoint to the drive and read in the signals from the (incremental) encoder.
	Last edited by: miami at: 7/7/2009 11:27 AM
Suggestion To thank Quote Answer

Share this page:

Share this page on...