Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

automatically load a recipe when a tag changes

Created by: G_R_E_Y_31 at: 1/27/2012 5:32 AM (4 Replies)

Rating (0)

Thanks 0

5 Entries

1/27/2012 5:32 AM	Rate (0)
G_R_E_Y_31 Bronze Member Joined: 5/26/2011 Last visit: 11/14/2024 Posts: 456 Rating: (7)	Hi Experts! [schnippschnapp] Now, I have a new problem to offer you guys!hehe.. But it seems it's just a simple one, here it goes: I want to automatically load a recipe when a tag changes, I can do this if I can trigger an event "SetDataRecordToPLC" whenever a corresponding boolean tag activates. How can I do this? Thanks for any response!
	Last edited by: O_Moderator at: 1/27/2012 11:09 AM new subject after splitting from /tf/WW/en/Posts/67317#top
Suggestion To thank Quote Answer

1/27/2012 2:01 PM	Rate (0)
Tweety Posts: 3037 Rating: (192)	Hello, You can this. Do you use an internal tag or a tag with communication of plc for the trigger tag? Do you use the area pointer "data record" ? data record is the name in WinCC flexible, i do not know the name of this area pointer in ProTool. Tweety
Tweety Posts: 3037 Rating: (192)
Suggestion To thank Quote Answer

1/29/2012 3:43 AM	Rate (0)
G_R_E_Y_31 Bronze Member Joined: 5/26/2011 Last visit: 11/14/2024 Posts: 456 Rating: (7)	Hi Tweety! I will use an external tag (from PLC) to trigger the "SetDataRecordToPLC" from the OP. Nope, I'm not using Area Pointer or Data Record.. But if it's required to do this function I need, then please teach me how to do it sir! Thanks for the response!

Suggestion To thank Quote Answer

1/30/2012 4:11 PM	Rate (0)
Tweety Posts: 3037 Rating: (192)	Hello, Do you have create a messageview and you see any error messages? You should use the area pointer "data mailbox". You can see with this area pointer if the transfer of the data record is completed without error. This is important.You must wait till the datarecord is transferred completely. Then you can trigger the function once again. You can see more about this area pointer in the following manual. See the chapter 2.4.1.8. You can see more information about the recipes in the following manual. See the chapter 8. SIMATIC HMI WinCC flexible 2008 WinCC flexible 2008 Compact/ Standard/ Advanced Tweety
Tweety Posts: 3037 Rating: (192)
Suggestion To thank Quote Answer

7/23/2015 11:38 AM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published by Jherson Andrade was deleted because of double post, the second thread you can find with the subject Data Record of the area pointer, TP700 and a PLC S7-1200, Error. Best regards Min_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on