Hi all,

I´m new handle the drive sinamics DCM (6RA8078-6FV62-0AA0). The issue is that I need configurar this drive in mode torque, with the software starter.
Looking for in the software starter only I see the option for work in modo speed.

Thanks in advance!

Dear Aslp,

I think you can use parameter p50084 for selecting between speed control and torque control.
Please also study function diagrams 6810 and 6830.

I have attached the above parameter and function diagram information from the list manual (Please refer attachment).

Regards
Ajay Gupta

New question published byAleksander EU... is split to a separate thread with the subject DCM must be switched between speed and torque, cant do change between that modes in my application.

Best regards
Min_Moderator