Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

f01910

Created by: mani@123 at: 7/26/2014 12:49 PM (5 Replies)

Rating (0)

Thanks 1

6 Entries

7/26/2014 12:49 PM	Rate (0)
mani@123 Posts: 9 Rating: (0)	Dear sir i am commissioning s120 cu 320-2dp drive 132kw ,here communication bw drive and plc is established but when i give the start cmd drive geting fault f01910 before all healthy,plz suport me its urjent.
mani@123 Posts: 9 Rating: (0)
Suggestion To thank Quote Answer

7/26/2014 1:15 PM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 12/20/2024 Posts: 22482 Rating: (3039)	Hello, get you only the f01910 or any other fault too? Is the PLC in RUN mode when the fault occurs? Regards Christoph

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users VSSL

7/27/2014 6:28 PM	Rate (0)
SandipPatel Posts: 2 Rating: (0)	f1910 mean there is problem in your profibus communication between plc and drive. if you are not using profibus communication then you may supress the fault.
SandipPatel Posts: 2 Rating: (0)
Suggestion To thank Quote Answer

7/28/2014 6:55 AM	Rate (0)
Krunal Shah Posts: 31 Rating: (1)	hi Mani, It could also happen when master slave settings changed. Make sure ur PLC is master and drives are slaves. Regards, Krunal Shah
Krunal Shah Posts: 31 Rating: (1)
Suggestion To thank Quote Answer

7/30/2014 2:56 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 12/20/2024 Posts: 5974 Rating: (820)	Hello, If your setup has already been working and you change something in your plc like function blocks or hardware configuration sometimes the cpu is stopped and then you get the fault F01910 autmatically - there is nothing wrong with it, because you can acknwoledge the fault when the plc is running again.
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

1/23/2017 4:24 PM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published by KaaNN is split to a separate thread with the subject All drives frequently gives F01910 fault and stop working. Best regards Min_Moderator

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on